Problems Appearance When Screw Oil Press Machine Pressing Soybean

Post time:2014-12-19

This article summarizes problems appearance during soy oil processing project....


There will be some problems appearance when using screw oil press machine pressing soybean if people operate the oil expeller in incorrect way. This article summarizes problems appearance during soy oil processing project.

1.During oil processing process, there may be oil return phenomenon, that is to say oil in the hopper. To squeeze the soybeans, oil return is rare to see. Oil return phenomenon is common for pressing high oilseed. If there is this phenomenon, adjusting the gap, and if the 100 type screw oil press machine, besides adjusting the discharge gap, you need loosen a press tight silk, increasing the garden drainage oil clearance.
2. The screw oil press machine don’t feed material, and cake outflow smoothly or can’t outflow.
The main reason of above is that at the beginning using of the new screw oil press machine. Sometimes hopper congestion dialing feed screw turned cause does not feed on leaves. If the oilseed water content is not suitable, you should adjust the water problem. If it is not the water problem, then you should operate the screw oil press machine according the manual operation strictly. You should control slow feed, standby temperature over 80 degrees, then starting normal squeeze.


Wish the above problem can help you when operating the screw oil press machine for making soy oil. Any problem about it, please feel free to contact us.


Need consultation?

Send us a message, we will contact you soon.